FAQs

Products

Instrument Transformer Testing Circuit Breaker Testing Resistance Measurement Grounding Connection Device Parameters Tester Capacitance and Dissipation Factor Testing

<!--[if !supportLists]-->1.1 1. Instrument Cannot Power On / Circuit Breaker Trips During Operation<!--[if !supportLists]-->1.1.1 1.1 ···

Before troubleshooting the instrument, verify that the Control and DC Power jumper connections on the front panel are correctly installed.Du···

3.1 Verify the Timing Contact Channels (Hardware Check)Short-circuit the timing channel A1–N1 using a jumper wire.Observe the timing status ···

HandyGeneral vacuum circuit breakers require research on bounce parameters, while plug-in metal contact circuit breakers with voltage levels···

Combination and division test setupThe closing and opening control time of the high-voltage switch tester produced by our company refers to ···

The wiring instrument is equipped with two sets of contact wiring terminals as shown in the figure below. A1, B1, C1, A2, B2, C2, N1 are gro···

Firstly, the speed test results need to be compared with the factory report. Therefore, the selection of speed sensors needs to be kept "in ···

Usually, the sensor type options for Handi switch testers include analog linear, digital rotation, digital linear, acceleration, and gyrosco···

When using the XC355 simulated rotation sensor with blind spots (the effective angle of XC355 is 345 °± 2 °), it should be ensured that the ···

In the vast majority of cases, instruments use input type. (Acceleration and gyroscope sensors can only use input type) Input type refers to···

Error limit of protective current transformer accuracy levelUnder rated primary currentCurrent error（±%）Under rated primary currentphase dif···

From the above figure, it can be seen that the primary current IP of the current transformer is divided into two parts after being transform···

<!--[if !supportLists]-->1. When there is inaccurate measurement of the transformation ratio, the following measures can be taken:<!--···

1. If overcurrent protection occurs during CT excitation characteristic testing, the following methods can be tried to solve it:(1) Reduce t···

The transformer tester produced by our company can measure electromagnetic transformers and ensure that the measured transformer ratio accur···

Solution for Transformer Tester Unable to Generate Reports:At present, the supporting software supports calling Microsoft Office software to···

Short circuit S1 of the instrument's "voltage output", S1 of "voltage measurement 1", and P1 of "voltage measurement 2"; Short circuit S2 fo···

P-level current transformers can determine whether the accurate limit factor KALF is qualified by measuring the excitation curve. The method···

Q: How to check if the instrument is working properly?Answer: Short circuit the power outputs A, B, and C with the voltage measurement UA, U···

Q: What aspects should be paid attention to when testing the mutual inductance of line parameters?Answer:1、 Before testing the mutual induct···

Q: What aspects should be paid attention to when testing the wiring of line parameters?Answer:1. The protective grounding column on the inst···

Q: How to handle the small impedance angle in the zero sequence impedance test results?Answer: The small impedance angle of zero sequence im···

Q: How to deal with abnormal output voltage of one phase of the instrument?Answer:1. If the abnormal phase has a normal output current and a···